Wolf Sub-Zero 700TF Przewodnik Instalacji Pobierz pdf (Strona 18)

Integrated Installation 18

Installation Checklist

o ensure a safe and proper installation, the following

checklist should be completed by the installer to ensure

that no part of the installation has been overlooked.

INSTALLATION CHECKLIST

Has the anti-tip bracket been installed properly and is

it making contact with the unit?

Is the unit level? Are all leveling legs making contact

with the floor?

Is the power cord plugged into a properly grounded

3-prong outlet, which has been installed in accordance

with all applicable electrical codes?

Is the water supply connected for units with an

automatic ice maker? Have you checked for leaks?

Has the kickplate/grille been installed properly?

Are panels attached securely and properly aligned?

Has the door been aligned for proper appearance and

operation?

Does the customer understand the unit's operation?

Have you given the customer the warranty package?

Have any installation or service problems been noted

on the product registration card? Has the registration

card been mailed in?

Have stainless steel panels been inspected for any

imperfections? This is to be done by the dealer or

installer with the customer upon completion of the

installation. Classic, platinum and carbon stainless

steel panels are covered by a limited 60-day parts and

labor warranty for cosmetic defects.

90° door stop.

Dual Installations

hen two integrated units are installed closer than 2" (51)

to one another, it is necessary to use the Sub-Zero dual

installation heater kit (7007529 or 7007530). The heater

plate from this kit must be attached to the left side exterior

of the right-hand unit before the units are slid into

position.

Contact your Sub-Zero dealer for the proper components

and installation instructions. To obtain local dealer infor-

mation, visit the showroom locator section of our website,

subzero.com. For questions relative to the installation,

call Sub-Zero at 800-222-7820.

90° Door Stop

All integrated tall units have a 90° door stop built into the

hinge system. Use the blade edge of a standard screw-

driver and rotate the cam in the center portion of

the hinge until you reach the stop. You must make this

adjustment to both the bottom and top hinge. Refer to the

illustration below.

1 2 ... 13 14 15 16 17 18 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Wolf Sub-Zero 700TF Przewodnik Instalacji Strona 18

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Wolf Sub-Zero 700TF