
Integrated Use & Care 16
Lighting Information
TOP COMPARTMENT LIGHTING
The top compartment of the integrated tall unit contains
standard 40-watt appliance bulbs (3030030).
To replace the light bulbs, you must first remove the light
shield. Place your hands under the light shield and release
the two clips on the back, then lift up and slide back
slowly until the key slots on the side of the light shield
drop past the mounting studs in the side walls. Remove
the light shield. The bulbs are now accessible. Replace the
bulbs and follow the reverse steps to reposition the light
shield. Refer to the illustration below.
DRAWER COMPARTMENT LIGHTING
Each drawer compartment has a standard 25-watt
appliance bulb (3030060) recessed into the top of the
compartment. Refer to the illustration below.
To replace the light bulb, pull the drawer out to its full
extension or remove the drawer completely. Refer to
drawer removal on page 12. Replace the bulb and follow
the reverse steps to reinstall the drawer.
Shut off power to the unit at the circuit breaker
before replacing light bulbs. Wear protective gloves
when handling bulbs.
Top compartment lighting. Drawer compartment lighting.
90° Door Stop
Y
our integrated tall unit is equipped with a built-in 90°
door stop. You can easily actuate the stop by using a
blade-type screwdriver and advancing the brass fitting in
both the top and bottom door hinges.
You must actuate both stops at 90° if you want to safely
use the door. You can go to the maximum 105° opening by
using the screwdriver and advancing the brass cam to the
next stop.
90° door stop.
When the door is open to 105°, the door panel,
depending on its thickness, may strike the face
frame of the unit causing serious damage.
The door swing on tall units may cause severe finger
pinching or damage to the unit. Watch that fingers
are not placed in the door opening on the hinge side
when the door is open.
Komentarze do niniejszej Instrukcji